These series valves handle the neg common switching in the base lead wires

These series valves handle the neg common switching in valve cover circuit board.

The maximum amount that can be stacked together based on the number of available traces on the circuit board

The maximum amount that can be stacked together based on the number of available traces on the circuit board

The maximum amount that can be stacked together based on the number of available traces on a specially ordered MAConnect board.
Note: Different electrical adapters must ordered

92 – Model number option
82 – Modification number 1969

Current adapters available for MAConnect valve series offered with a 30 solenoid capability.

92 – Term Strip M-92017 –XX Mod1845
82 – 37 Pin CPC –M-82016-37-XX

All valves that are attached to our serial interface stacks must be positive commons.

None of the electrical adapters are polarity sensitive. When a negative common adapter is ordered, the only modification to the product is a label change.

The coil itself is not polarity sensitive. A negative common modification only becomes necessary when polarity sensitive devices such as Diodes or LEDs are ordered

The following series lights are not polarity sensitive.  The 45 and 82 series lights are bipolar while the 36 and 46 series utilize dual leds on the valve cover circuit board.

The maximum voltage that can be applied to the 82 and 92 series MAConnect valves is 240 volts. The maximum voltage for all other MAConnect series valves is 120 volts.

For ease of adding valves to a MAConnect stack, the electrical adapter should be ordered on the side the tie rods fasten. This is not a concern for series that fasten toward each other.

Fasten to the left: 32/42/47/38/48/92/44/36/46
Fasten to the right: 82/93
Fasten toward each other: 45/ISO I/ISO II

36 / 44 / 45 / 46 / 47 / 82
93 / ISO I / ISO II

This is a negative common modification for those series valves where the polarity is changed in the base lead wires.

This is a negative common modification for those series valves where the polarity is changed in the valve cover circuit board.

The part numbering system for these valves has an option for ordering negative commons.

This modification is used to order a single solenoid valve on a MAConnect manifold base wired for doubles.Example: 92B-AAF-BJ1-DM-DDAP-1DM=1842

This modification is for a single remote device. A double circuit board and a 4-pin output connector are installed in the right hand manifold end station.

Modify the MAConnect manifold with a 30-solenoid capability circuit board. See "General MAConnect Information".